Heater operation
NOTE
● When the “
” button or “
”
button is pressed the air conditioner compressor automatically operates to quickly
defog the windshield. However the indicator on the air conditioner button will not
illuminate. At the same time, the air inlet selection is automatically set to “outside
air” mode.
● Warm air also comes out from the right and left air outlets. To stop warm airflow
from these outlets, turn the corresponding wheel to the “
”
position.
See also:
In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink® button after
programming, contact HomeLink® at
www.homelink.com or call 1-800-355-
3515 for assistance. ...
Cooling and dehumidifying in high humidity and low temperature weather condition
Under certain weather conditions (high relative humidity, low temperatures, etc.)
a small amount of water vapor emission from the air outlets may be noticed. This
condition is normal and does not ...
Non-turbo models
It is unnecessary to check the deflection of
the drive belt periodically because your
engine is equipped with an automatic belt
tension adjuster. However, replacement of
the belt should be don ...
