Heating

To direct warm air toward the floor: 1. Set the air inlet selection button to the OFF position.

2. Press the “3. Set the temperature control dial to the most comfortable level.” button.


3. Set the temperature control dial to the most comfortable level.

4. Set the fan speed control dial to the desired speed.

    See also:

    Inserting a disc in a desired position
    1. Briefly press the “LOAD” button. If the magazine in the player has an idle position where you can insert a disc, the disc number indicator associated with the idle position will blink. The p ...

    Rear ashtray (STI – if equipped)
    Rear ashtray (STI – if equipped) The rear ashtray is located on the upper side of the back of the center console. To open the ashtray, pull the upper edge of the lid. Fully close the lid after using ...

    Immobilizer system
    This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” ...