Manual mode
In the manual mode, you can use the center differential control switch to adjust the initial LSD torque as desired. When this mode is selected, the “AUTO” indicator light on the combination meter turns off.
See also:
State emission testing (U.S. only)
WARNING
Testing of an All-Wheel Drive vehicle must NEVER be performed on a single two-wheel
dynamometer. Attempting to do so will result in uncontrolled vehicle movement and
may cause an accident ...
Setting passkey
1. Select the “SET PASSKEY” menu.
After the currently set passkey is displayed,
a new passkey can be entered.
2. Input the new passkey by operating
the “TUNE/TRACK/CH” dial.
3. Select the “CONF ...
Lubrication oil circulation in the refrigerant circuit
Operate the air conditioner compressor at a low engine speed (at idle or low
driving speeds) a few minutes each month during the off-season to circulate its
oil. ...