Selecting turn signal lights operation
When the remote keyless entry system is used, the turn signal lights flash. However, the turn signal lights flashing operational non-operational setting can be changed.
Models with genuine SUBARU navigation system:
The setting can be changed using the navigation monitor. For details, refer to the Owner’s Manual Supplement for the navigation system.
Models without genuine SUBARU navigation system:
The setting can be changed by your SUBARU dealer. Contact your SUBARU dealer for details.
See also:
Low beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side).
Left-hand side
2. Use a screwdriver to remove the secured clip of t ...
Tilt/telescopic steering wheel
WARNING
Do not adjust the steering wheel tilt/ telescopic position while driving. This
may cause loss of vehicle control and result in personal injury.
1. Adjust the seat position. Refer to “Fro ...
Rear seatbelts (except rear center seatbelt on 5-door models)
1. Sit well back in the seat.
2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it o ...