Brake fluid level warning"> Subaru Outback (BR) - <span lang="ru">Brake fluid level warning</span> - Brake system warning light
Subaru Outback manuals

Subaru Outback (BR): Brake fluid level warning

Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Brake system warning light / Brake fluid level warning

This light illuminates when the brake fluid level has dropped to near the “MIN” level of the brake fluid reservoir with the ignition switch in the “ON” position and with the parking brake released.

If the brake system warning light should illuminate while driving (with the parking brake released and with the ignition switch positioned in “ON”), it could be an indication of leaking of brake fluid or worn brake pads. If this occurs, immediately stop the vehicle at the nearest safe place and check the brake fluid level. If the fluid level is below the “MIN” mark in the reservoir, do not drive the vehicle. Have the vehicle towed to the nearest SUBARU dealer for repair.

READ NEXT:

 Electronic Brake Force Distribution (EBD) system warning

The brake system warning light also illuminates if a malfunction occurs in the EBD system. In that event, it illuminates together with the ABS warning light. The EBD system may be malfunctioning i

 Electronic parking brake system warning

The brake system warning light flashes when the electronic parking brake system is malfunctioning. If the warning light flashes, promptly park in a safe location as soon as possible and contact yo

 Hill Holder indicator light

WARNING If the Hill Holder indicator light does not illuminate even when the Hill Holder switch is pressed to activate the Hill Holder function, the electronic parking brake system may be malfu

SEE MORE:

 How to re-stow bars

CAUTION Do not use the bars as roof rails when the bars are stowed. 1. Pull out the crossbars from the roof rail holders by pulling up the covers. 2. Slide the bars in the direction shown in the illustration. 3. Install the bars into the holders. 4. Make sure that the latches are fitted s

 Primary Pulley and Secondary Pulley

A: REMOVAL NOTE: Always replace primary pulley and secondary pulley as an assembly because they are non-disassembled parts. 1) Remove the transmission assembly from the vehicle. <Ref. to CVT-55, REMOVAL, Automatic Transmission Assembly.> 2) Remove the air breather hose. <Ref. to CVT-132,

© 2010-2024 Copyright www.suoutback.com