Select lever
The select lever has four positions, “P”, “R”, “N”, “D” and also has a manual gate for using the manual mode.
See also:
Compass zone adjustment
Compass calibration zones
1. The zone setting is factory preset to
Zone 8. Refer to the “Compass calibration
zones” map shown above to verify that the
compass zone setting is correct for yo ...
When “CHECK DEVICE” is displayed
This message is displayed under the
following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-correspo ...
Refueling
Only one person should be involved in
refueling. Do not allow others to approach
the area of the vehicle near the fuel filler
pipe while refueling is in progress.
Be sure to observe any other p ...