High/low beam change (dimmer)

To change from low beam to high beam, push the turn signal lever forward. When


To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “on the combination meter is also on.”
on the combination meter is also on.

To switch back to low beam, pull the lever back to the detent position.

    See also:

    SI-DRIVE (STI)
    SI-DRIVE (SUBARU Intelligent Drive) works to maximize engine performance, control and efficiency. This system consists of three modes: Intelligent (I), Sport (S), and Sport Sharp (S#). By adjusting ...

    Temperature A, B, C
    The temperature grades are A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specif ...

    2011 Subaru Forester review
    The 2011 Subaru Forester arrived on my doorstep without much fanfare, looking quite modest and left in much the same way. Put simply: It didn't amaze me, but it did prove itself to be competent an ...