Light control switch

The light control switch only operates when the key is inserted into the ignition switch.

Regardless of the position of the light control switch, the illuminated lights are turned off when the key is removed from the ignition switch.

NOTE

● Even if the key is removed from the ignition switch, the lights can be illuminated by operating the light control switch position from OFF to and/or .
and/or ● If the drivers door is opened while the lights are illuminated and the key.


● If the drivers door is opened while the lights are illuminated and the key is removed from the ignition switch, the chirp sound informs the driver that the lights are illuminated.

CAUTION

● Use of any lights for a long period of time while the engine is not running can cause the battery to discharge.

● Before leaving the vehicle, make sure that the light control switch is turned to the OFF position. If the vehicle is left unattended for a long time with the light control switch set to a position other than OFF, the battery may be discharged.

See also:

Unlocking the doors
Press the button to unlock the drivers door. An electronic chirp will sound twice and the turn signal lights will flash twice. To unlock all doors and the rear gate (Outback), briefly press ...

Programming the transmitters
The remote keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to ...

Wheel alignment
*: The difference between right-hand camber and left-hand camber should be within 45 or less. ...