How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2.
Press the “
” or “
”
side of the “SEEK” button or tune the radio manually until the desired station frequency
is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store
the frequency. If the button is pressed for less than 1.5 seconds, the preceding
selection will remain in memory.
NOTE
● If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all stations stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset stations. . If a cell phone is placed near the radio, it may cause the radio to emit noise when the phone receives calls. This noise does not indicate a radio malfunction.
See also:
Navigation monitor (if equipped)
To clean the navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then care ...
Wheel alignment
*: The difference between right-hand camber and left-hand camber should be within
45’ or less. ...
Safety
Like the rest of Subaru's current lineup, the 2011 Tribeca is a Top Safety
Pick at the Insurance Institute for Highway Safety. It scores the agency's best
rating, Good, in front-, rear- and side-i ...
