Immobilizer system
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may indicate that immobilizer system may be malfunctioning. Contact your nearest SUBARU dealer immediately. In the event that an unauthorized key (for example, an unauthorized duplicate) is used, the security indicator light illuminates.
See also:
Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Open the cover
2) Pull down the wiper blade
2. Remove the wiper blade assembly by opening the cover and pulling it down in
the direction shown in t ...
2010 Subaru Tribeca review
Vehicles take years to create.
Unlike newspapers, which can create a new front page in the time it takes to
reset a ripped paper roll, cars and trucks don't magically transform themselves
during ...
For U.S.A
The following information has been compiled according to Code of Federal Regulations
“Title 49, Part 575”. ...