Setting guidance volume

To set the guidance volume, perform the following procedure.

1. Select the “SETUP” menu.

2. Select the “SYSTEM SETUP” menu.

3. Select “GUIDANCE VOL” by operating the “TUNE/TRACK/CH” dial.

4. Set the guidance volume by operating the “TUNE/TRACK/CH” dial.

    See also:

    Pulling off the fender lining
    It is necessary to pull off the fender lining when replacing some bulbs. 1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced. 2. Stop the eng ...

    Type A audio set (if equipped)
    Type A audio set (if equipped) The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. - Power and audio controls: refer to page - Radio operation: refer t ...

    Mirrors
    Always check that the inside and outside mirrors are properly adjusted before you start driving. ...