Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for deactivation mode. Refer to “Activating and deactivating the alarm system” F2- 16. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle’s alarm system for activation mode. Refer to “Activating and deactivating the alarm system” F2-16.
See also:
Low fuel warning light
The low fuel warning light illuminates when the tank is nearly empty [approximately 2.6 US gal (10.0 liters, 2.2 Imp gal)].
It only operates when the ignition switch is in the “ON” position.
NOTE
T ...
Engine oil
NOTE
• The engine oil consumption rate is not stabilized, and therefore cannot be determined until the vehicle has traveled at least several thousand miles (kilometers). Even after break-in, when the ...
Behind the Wheel
I believe the greatest obstacle facing Impreza shoppers is the car's power.
The new, smaller engine is less powerful than the previous generation's power
plant. Though the base car has shed 165 po ...
