Callback
1. Select the “CALL BACK” menu.
2. Press the OFF hook switch 
.
3. Select the desired number by turning the “TUNE/TRACK/CH” dial.
4. Perform either of the following procedures.
– Press the OFF hook switch .
– Press the “TUNE/TRACK/CH” dial, then select the “DIAL” menu.
See also:
When “CHECK DEVICE” is displayed
This message is displayed under the
following conditions.
- When there is a short in the USB bus
- When a non-corresponding device (for
example a USB mouse) is connected
- When a non-correspo ...
Tone and balance control
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the
following sequence.
Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The
control func ...
Steps for Determining Correct Load Limit
1. Locate the statement “The combined weight of occupants and cargo should never exceed XXX pounds” on your vehicle’s placard.
2. Determine the combined weight of the driver and passengers that will ...