If you have accidentally triggered the alarm system
To stop the alarm
Perform any of the following operations.
● Press any button on the remote transmitter.
● Turn the ignition switch to the “ON” position.
See also:
Programming rolling-code-protected garage door openers in the U.S.A.
If your garage door opener has a rolling code feature, program the HomeLink® Wireless Control System for it by following steps 1 through 5 in “Garage door opener programming in the U.S.A.”. Then conti ...
Checking the coolant level
Never attempt to remove the radiator cap until the engine has been shut off and has cooled down completely. Since the coolant is under pressure, you may suffer serious burns from a spray of boilin ...
Tilting moonroof
1) Raise
2) Lower
The raising function will only operate when the moonroof is fully closed. The
lowering function will only operate when the moonroof is raised.
Press the rear side of the “UP/D ...