Cruise control indicator light

This light illuminates when the “CRUISE” main switch is pressed.
NOTE
• If you press the “CRUISE” main switch button while turning the ignition switch “ON”, the cruise control function is deactivated and the cruise control indicator light flashes. To reactivate the cruise control function, turn the ignition switch back to the “Acc” or “LOCK” position, and then turn it again to the “ON” position.
• If this indicator light and the CHECK ENGINE warning light/malfunction indicator lamp flash simultaneously during driving, have the vehicle checked by your nearest SUBARU dealer.
See also:
Rear window wiper blade assembly (Outback)
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward you to remove it from the wiper arm. ...
Outback in the Market
Utility and crossovers go hand-in-hand, and the Outback comes up strong on
all the basics. Like every Subaru, its success will be limited by the
automaker's insistence on standard all-wheel drive, ...
Tire pressures and wear
Maintaining the correct tire pressures helps to maximize the tires’ service lives
and is essential for good running performance. Check and, if necessary, adjust the
pressure of each tire (includin ...
