To disengage the service mode
Turn the ignition switch to the “ON”
position, depress and hold the brake
pedal, then press and release the “
”
button on the remote control transmitter
three times. The system will pause for 1
second and flash the turn signal lights 1
time indicating that the system has exited
service mode.
NOTE
When taking your vehicle in for service,
it is recommended that you inform the
service personnel that your vehicle is
equipped with a remote control start
system.
See also:
Parking in cold weather
WARNING
Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of
the exhaust pipe and from around your vehicle if you park the vehicle in snow with
the engine running.
Do not ...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with the warning message
indicated by sending a signal from a sensor that is installed in each wheel when
tire pressure is severely low.
...
Floor mat
Retaining pins are located on the driver’s side floor.
The floor mat is secured using the built-in grommets, by placing the grommets
over the pins and pushing them downward.
CAUTION
Make sure ...