To turn off fuel consumption indicator display
The fuel consumption indicator display can be turned off.
To turn off this display, turn the ignition switch to the “LOCK” position and press the “+” button adjacent to the information display for approximately 5 seconds.
Then, the information display and the clock display will blink for 3 seconds to notify you that the fuel consumption display has been turned off.
To restore the indicator, once again press the “+” button for approximately 5 seconds.
NOTE
- The initial display setting of the fuel
consumption indicator of your vehicle
has been set to operational at the time
of shipment from the factory.
- The average fuel consumption is calculated even while the indicator is not displayed.
- Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.
See also:
Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button
you wish to reprogram. DO NOT release
the button until step 4 has been completed.
2. When the HomeLink® indicator light
begins to flash slowly (after appr ...
Fuel economy hints
The following suggestions will help to save fuel.
• Select the proper gear position for the speed and road conditions.
• Avoid sudden acceleration or deceleration.
Always accelerate gently until yo ...
Turn signal indicator lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as ...