Shift lock function
The shift lock function helps prevent the improper operation of the select lever.
● The select lever cannot be operated unless the ignition switch is turned to the “ON” position and the brake pedal is depressed.
● The select lever cannot be moved from the “P” position to any other position before the brake pedal is depressed. Depress the brake pedal first, and then operate the select lever.
● Only the “P” position allows you to turn the key from the “Acc” position to the “LOCK” position and remove the key from the ignition key cylinder.
● If the ignition switch is turned to the “LOCK” position while the select lever is in the “N” position, the select lever may not be moved to the “P” position after a period of time. Therefore, move the select lever to the “P” position with the brake pedal depressed soon after the ignition switch is turned to the “LOCK” position.
See also:
Front fog light switch (if equipped)
Front fog light switch (if equipped)
The front fog lights operate only when the
low beam headlights are illuminated.
However, the front fog lights turn off when
the headlights are switched t ...
Selecting reverse gear
1) Slider
You must raise the slider and hold it in that position before you can move the shift lever to the “R” position.
To change gears, fully depress the clutch pedal, move the shift lever, and ...
Changing the coolant
WARNING
Never attempt to remove the radiator cap until the engine has been shut off and
has cooled down completely. Since the coolant is under pressure, you may suffer
serious burns from a spray ...