Remote start confirmation transmitter feature

Your remote engine start transmitter is equipped with a unique bidirectional confirmation feature. This feature will allow the transmitter’s backlit button to display the status of the system under the condition that the vehicle and transmitter are within the operational range of the system. Typical transmitter button flash sequences are outlined in the following chart.

Entering the vehicle following remote engine start shutdown


    See also:

    Heating
    Heating To direct warm air toward the floor: 1. Set the air inlet selection button to the OFF position. 2. Set the airflow control dial to the “” position. 3. Set the temperature control dial to t ...

    Compass calibration
    1. If a “C” is displayed in the compass window, the compass needs to be calibrated. 2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction. 3. You can also ...

    Before driving your vehicle
    Before entering the vehicle, remove any snow or ice from your shoes because that could make the pedals slippery and driving dangerous. While warming up the vehicle before driving, check that the ac ...