Heating and defrosting

To direct warm air toward the floor and the windshield: 1. Set the air inlet selection button to the OFF position.

2. Press the “3. Set the temperature control dial to the most comfortable level.” button.


3. Set the temperature control dial to the most comfortable level.

4. Set the fan speed control dial to the desired speed.

    See also:

    Fan speed control dial
    Fan speed control dial The fan operates only with the ignition switch in the ON position. The fan speed control dial is used to select the AUTO (automatic control) mode or to select the des ...

    To increase the speed (by button)
    To increase the speed (by button) Push the “RES/ACC” button and hold it until the vehicle reaches the desired speed. Then, release the button. The vehicle speed at that moment will be mem ...

    Immobilizer system
    This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” ...