Preset buttons

How to preset channels

1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.

2. Select the desired channel.

3. Press one of the preset buttons for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory.

NOTE

If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels.

    See also:

    REV indicator light (STI)
    This light illuminates when the engine speed reaches a level set by driver or when the tachometer needle enters the red zone. ...

    MMT
    Some gasoline contains an octane-enhancing additive called MMT (Methylcyclopentadienyl Manganese Tricarbonyl). If you use such fuels, your emission control system performance may deteriorate a ...

    Rear window wiper and washer switch – 5-door
    : Washer (accompanied by wiper operation) ON: Continuous INT: Intermittent OFF: Off : Washer ...