Daytime running light system
WARNING
The brightness of the illumination of the high beam headlights is reduced by
the daytime running light system. The light switch must always be turned to the
“
” position when it is dark outside.
The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions.
● The parking brake is fully released.
● The light switch is in the “OFF” or “ ” position.
● The light switch is in the “AUTO” position and the headlights do not turn on automatically.
● The select lever is in a position other than the “P” position (AT and CVT models).
NOTE
When the light switch is in the “ ” position, the front side marker lights, tail lights and license plate lights are illuminated.
See also:
Behavior with key lock-in prevention function non-operational
- If the lock lever is turned to the rear
(“LOCK”) position with the driver’s door
open and the driver’s door is then closed
with the lock lever in that position, the
driver’s door is locked.
...
Coolant temperature low indicator light/Coolant temperature high warning light
CAUTION
● After turning the ignition switch to the “ON” position, if this indicator light/warning
light behaves under any of the following conditions, the electrical system may be
malfuncti ...
Seatbelt warning light and chime
Your vehicle is equipped with a seatbelt warning device at the driver’s and front passenger’s seat, as required by current safety standards.
With the ignition switch turned to the “ON” position, th ...