Parking brake lining

1. Drive the vehicle at a speed of approximately 22 mph (35 km/h).

2. With the parking brake release button pushed in, pull the parking brake lever SLOWLY and GENTLY (pulling with a force of approximately 33 lbf [147 N, 15 kgf]).

3. Drive the vehicle for approximately 220 yards (200 meters) in this condition.

4. Wait 5 to 10 minutes for the parking brake to cool down. Repeat this procedure.

5. Check the parking brake stroke. If the parking brake stroke is out of the specified range, adjust it by turning the adjusting nut located on the parking brake lever.

A safe location and situation should be selected for break-in driving.

A safe location and situation should be selected for break-in driving.

Pulling the parking brake lever too forcefully may cause the rear wheels to lock. To avoid this, be certain to pull the lever up slowly and gently.

Pulling the parking brake lever too forcefully may cause the rear wheels to lock. To avoid this, be certain to pull the lever up slowly and gently.

    See also:

    2011 Subaru Legacy review
    The Subaru Legacy has been redesigned for 2010 and now boasts a bigger backseat and improved gas mileage, with the same nimble steering the 2009 model had. Snowbelt drivers will appreciate its sta ...

    Operation
    The SRS side airbag and SRS curtain airbag can function only when the ignition switch is in the “ON” position. The driver’s and front passenger’s SRS side airbags and SRS curtain airbags deploy ...

    Replacing the battery
    CAUTION ● Do not let dust, oil or water get on or in the transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the transmitter when replacing ...