Snow tires

• When replacing original tires with winter (snow) tires, make sure you use only the same size, construction and load range as the original tires listed on the tire placard. Using other sizes and construction may affect speedometer/ odometer calibration and clearance between the body and tires. It also may be dangerous and lead to loss of vehicle control.

• When replacing original tires with winter (snow) tires, make sure you use only the same size, construction and load range as the original tires listed on the tire placard. Using other sizes and construction may affect speedometer/ odometer calibration and clearance between the body and tires. It also may be dangerous and lead to loss of vehicle control.

• You must install four winter tires that are of the same size, construction, brand, and load range.

Mixing other sizes or constructions may result in severe mechanical damage to the drive train of your vehicle and may affect ride, handling, braking and speedometer/odometer calibration.

It also may be dangerous and lead to loss of vehicle control.

• Do not use a combination of radial, belted bias or bias tires since it may cause dangerous handling characteristics and lead to an accident.

See also:

Windows
WARNING To avoid serious personal injury caused by entrapment, always conform to the following instructions without exception. ● When operating the power windows, be extremely careful to pre ...

Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low. The tire pressure m ...

To arm the system using power door locking switches
1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors and the rear g ...