Hill start assist system (MT models – if equipped)
The Hill start assist system is a device only for helping the driver to START the vehicle on an uphill grade. To prevent accidents when the vehicle is parked on a slope, be sure to firmly set the parking brake.
When setting the parking brake, make sure that the vehicle remains stationary when the clutch pedal is released.
The Hill start assist system is a device to make starting on an uphill grade easier.
On an uphill grade, when the clutch pedal is depressed while the brake pedal is also depressed, braking power is maintained temporarily by the Hill start assist system when the brake pedal is released. The driver is therefore able to start the vehicle the same way as on a level grade, just using the clutch and accelerator pedal.
The Hill start assist system does not operate when the vehicle is facing downhill.
And the Hill start assist system may not operate on slight grades.
When starting in reverse and using the Hill start assist system, a braking effect may be felt even after the brake pedal has been released. However, this braking effect should disappear once the clutch pedal is released.
A slight jolt may be felt when the vehicle begins to move forward after being reversed.
If the braking power of the Hill start assist system is insufficient after the brake pedal is released, apply more braking power by depressing the brake pedal again.
See also:
How to preset stations
1. Press the “FM/AM” button to select FM1, FM2, FM3 or AM reception.
2. Press the “” or “”
side of the “SEEK” button or tune the radio manually until the desired station frequency is displayed.
3. ...
If you park your vehicle in case of an emergency
The hazard warning flasher should be
used in day or night to warn other drivers
when you have to park your vehicle under
emergency conditions.
Avoid stopping on the road. It is best to
sa ...
Channel scan
Type A and B audio
Type C audio
Press the “SCAN” button to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. ...