BEEP setting

A beep sound (operation sound) that occurs when the audio system is operated can be set ON/OFF. The initial setting is ON.

    See also:

    Initializing the registered data
    To initialize the registered data, perform the following procedure. 1. Select the “SETUP” menu. 2. Select the “SYSTEM SETUP” menu. 3. Select “INITIALIZE” by operating the “TUNE/TRACK/CH” dial. 4. ...

    Skip channel selection
    When in the SAT mode, press the “SEEK” button “” or “” continuously to change to the channel selection mode. Pressing the “SEEK” button “” changes the channel up by 10 steps each time. Pressin ...

    Catalytic converter
    WARNING ● Avoid fire hazards. Do not drive or park the vehicle anywhere near flammable materials (e.g. grass, paper, rags or leaves), because the catalytic converter operates at very high t ...