Rear center seating position
The head restraint is not intended to be used at the lowest position.
Before sitting on the seat, raise the head restraint to the click position.
1) When not used (lowest position)
2) When used (click position)
1) Head restraint
2) Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while pressing the release button on the top of the seatback.
To remove:
While pressing the release button, pull out the head restraint.
To install:
Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks.
When the rear-center seating position is occupied, raise the head restraint to an appropriate position depending on your sitting height. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
See also:
Vehicle identification
1) Emission control label
2) Vehicle identification number
3) Certification and bar code label
4) Tire inflation pressure label
5) Vehicle identification number plate
6) Model number label
7) ...
Selecting category (only when connecting iPod®)
When the “LIST” button is pressed for less than 1.5 seconds, the iPod® menu is displayed.
Each time you turn the “TUNE/TRACK/ CH” dial clockwise, the displayed category changes in the following seq ...
Driving in foreign countries
When planning to use your vehicle in
another country:
- Confirm the availability of the correct
fuel. Refer to “Fuel requirements”.
- Comply with all regulations and requirements
of each coun ...