Replacing bulbs
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.
Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart”.
See also:
Disarming the system
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice. The fla ...
Door open warning light
The door open warning light illuminates if
any door or the rear gate is not fully
closed.
Always make sure this light is out before
you start to drive. ...
AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminates when t ...