Monitor (if equipped)
To clean the audio/navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent.
NOTE
- Do not spray neutral detergent directly
onto the monitor. Doing so could
damage the monitor’s components.
- Do not wipe the monitor with a hard cloth. Doing so could scratch the monitor.
- Do not use cleaning fluid that contains thinner, gasoline, or any other volatile substance. Such cleaning fluid could erase the lettering on the switches at the bottom of the monitor.
See also:
Checking the oil level
AT models
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Pull ...
Setting guidance volume
To set the guidance volume, perform the following procedure.
1. Select the “SETUP” menu.
2. Select the “SYSTEM SETUP” menu.
3. Select “GUIDANCE VOL” by operating the “TUNE/TRACK/CH” dial.
4. Set t ...
Driving on grades
● Before going down a steep hill, slow down and shift into lower gear (if necessary,
use 1st gear) in order to utilize the overheating of your vehicle’s brakes. Do not
make sudden downshifts ...
