R (Reverse)
This position is for backing the vehicle.
To shift from the “N” to “R” position, stop the vehicle completely then move the lever to the “R” position.
When the ignition switch has been turned to the “LOCK” position, movement of the select lever from the “N” position to the “R” position is possible for a limited time period by depressing the brake pedal, and then it becomes impossible. For details, refer to “Shift lock function”.
See also:
Operating the windows
To open: Press the switch down and hold it until the window reaches the desired
position.
To close: Pull the switch up and hold it until the window reaches the desired
position. When the lock s ...
Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connector.
...
Shift lock function
The shift lock function helps prevent the improper operation of the select lever.
● The select lever cannot be operated unless the ignition switch is turned to
the “ON” position and the brake ...