Heater operation
NOTE
- Models with air conditioner system:
When the “
” or “
”
position is
selected, the air conditioner compressor
automatically operates regardless
of the position of the air conditioner
button to defog the windshield more
quickly. At the same time, the air inlet
selection is automatically switched to
the OFF position (outside air). However,
the air conditioner indicator light
does not illuminate at this time.
- When defrosting, defogging or heating, warm air is also emitted from the right and left air outlets. To stop warm airflow from these outlets, turn the corresponding thumb wheel down.
See also:
START
CAUTION
Do not turn the ignition switch to the “START” position while the engine is running.
The engine is started in this position. The starter cranks the engine to start
it. When the key is rele ...
AUTO button
FULL AUTO mode operation:
When the “AUTO” button is pressed, the indicator light “FULL AUTO” on the display
illuminates. In this state, fan speed, airflow distribution, air-inlet control,
and a ...
To close the moonroof
Push the switch to the “CLOSE” side then
quickly release it to close the moonroof.
The moonroof will stop at a position 8 in
(20 cm) away from the fully closed
position. Push the switch again t ...