Daytime running light system (if equipped)

Subaru Forester / Subaru Forester Owners Manual / Keys and doors / Light control switch / Daytime running light system (if equipped)

The brightness of the illumination of the high beam headlights is reduced by the daytime running light system.

The light switch must always be turned to the “when it” position when it is dark outside.

The high beam headlights will automatically illuminate at reduced brightness when the engine has started, under the following conditions:
- The select lever is in a position other than the “P” position (AT models).

- The parking brake is fully released.

- The light switch is in the “OFF” or “position.” position.

NOTE
When the light switch is in the “position, the front side marker lights,” position, the front side marker lights, tail lights and license plate lights are also illuminated.

    See also:

    Floor mat
    Retaining pins are located on the driver’s side floor. The floor mat is secured using the built-in grommets, by placing the grommets over the pins and pushing them downward. CAUTION Make sure ...

    Replacing the battery
    CAUTION ● Do not let dust, oil or water get on or in the transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the transmitter when replacing ...

    Type B audio set (if equipped)
    The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9 ● ...