Odometer/Trip meter

Type A
Type A

1) Trip knob

Type B
Type B

1) Trip knob

This meter displays the odometer and two trip meters when the ignition switch is in the “ON” position.

If you press the trip knob when the ignition switch is in the “LOCK” or “Acc” position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off.

The display can be switched as shown in the following illustrations by pressing the trip knob.

Type A:

*: or ,

*: and or or and or, and cannot or cannot cannot be displayed when the ignition switch is in the “ON” position.

Type B:

*:

*: or or the ignition switch is in the “ON” position. cannot be displayed when the ignition switch is in the “ON” position.

See also:

Tire rotation direction mark
Example of tire rotation direction mark 1) Front If the tire has a rotation direction specification, the tire rotation direction mark is placed on its sidewall. When you install a tire that has ...

Main fuse
Main fuse box The main fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. Check the main fuses if any electrical component fails to ...

Gasoline for California-certified LEV
If your vehicle was certified to California’s low emission vehicle (LEV) standards as indicated on the underhood tune-up label, it is designed to optimize engine and emission performance with ...