Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off.
Do the following to deactivate the audible signal. You can also use the same steps to restore the function.
1. Sit in the driver’s seat and shut all doors and the rear gate.
2. Hold down the UNLOCK side of the power door locking switch.
3. While holding down the “UNLOCK” side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after step 2.
4. Open and close the driver’s door once within 10 seconds after step 3.
5. The turn signal lights flash 3 times to indicate completion of the setting.
You may have the above settings done by your SUBARU dealer. Contact your SUBARU dealer for details. For models with a genuine SUBARU navigation system, the settings can be changed using the navigation monitor. For details, refer to the Owner’s Manual Supplement for the navigation system.
See also:
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and accessories.
3. Depress the clutch pedal to the floor and shift the shift lever into neutral. Hold the clutch pedal to the floor while ...
A Larger, Classier Cabin
At a time in automotive history when vehicles' shoulder lines are getting
high enough to make a submariner claustrophobic, the 2012 Impreza is more like a
skiff. The 2012's windowsills are almost ...
Front passenger’s SRS frontal airbag
The front passenger’s SRS frontal airbag uses a dual stage inflator. The inflator
operates in different ways depending on the severity of impact.
The total load on the seat is monitored by the pass ...