Wiper operation when snowing

Before driving in cold weather, make sure the wiper blades are not frozen to the windshield or rear window.

If the wiper blades are frozen to the windshield or rear window, perform the following procedure.

● To thaw the windshield wiper blades, use the defroster with the airflow selection in “warmth until the wiper blades are completely thawed. Refer to “Climate control”” and the temperature set for maximum
warmth until the wiper blades are completely thawed. Refer to “Climate control” F4-1.

● If your vehicle is equipped with a wiper deicer, use it. It is helpful to thaw the windshield wiper blades. Refer to “Defogger and deicer” F3-34.

● To thaw the rear wiper blade, use the rear window defogger. Refer to “Defogger and deicer” F3-34.

When driving in snow, if frozen snow starts to stick on the surface of the windshield despite wiper operation, use the defroster with the airflow selection in “and the temperature set for maximum warmth. After the windshield gets warmed enough
and the temperature set for maximum warmth. After the windshield gets warmed enough to melt the frozen snow on it, wash it away using the windshield washer. Refer to “Windshield washer” F3-33.

Snow stuck on the wiper arm prevents the wiper from working effectively. If snow is stuck on the wiper arm, pull off the road to a safe place, then remove it. If you stop the vehicle at road side, use the hazard warning flasher to alert other drivers. Refer to “Hazard warning flasher” F3-5. We recommend use of non-freezing type wiper blades (winter blades) during the seasons you could have snow and freezing temperatures. Blades of this type give superior wiping performance in snowy conditions. Be sure to use blades that are suitable for your vehicle.

CAUTION

During high-speed driving, nonfreezing type wiper blades may not perform as well as standard wiper blades. If this happens, reduce the vehicle speed.

NOTE

When the season requiring non-freezing type wiper blades is over, replace them with standard wiper blades.

    See also:

    Reprogramming a single HomeLink® button
    1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light begins to flash slowly (after approximat ...

    Non-turbo models
    The non-turbo engine is designed to operate using unleaded gasoline with an octane rating of 87 AKI or higher. ...

    Battery drainage prevention function
    If a door or the rear gate (Outback) is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage ...