To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
● Shift the select lever into the “N” position (AT and CVT models).
● Shift the shift lever into the neutral position (MT models only).
The cruise control set indicator light in the combination meter turns off when the cruise control is canceled.
To resume the cruise control after it has been temporarily canceled and with vehicle speed of approximately 20 mph (32 km/h) or more, press the “RES/SET” switch to the “RES” side to return to the original cruising speed automatically.
The cruise control set indicator light in the combination meter will automatically illuminate at this time.
See also:
Tether anchorage location
Outback
Three tether anchorages, i.e., ones for the right, center and left positions,
are already installed on the rear edge of the roof. Open the cover flap to use each
anchorage. ...
In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink® button after
programming, contact HomeLink® at
www.homelink.com or call 1-800-355-
3515 for assistance. ...
Unfastening the seatbelt
Unfastening the seatbelt
Push the release button of the center
seatbelt buckle (on the left-hand side) to
unfasten the seatbelt.
NOTE
When the seatback is folded down for
greater cargo are ...