Use of engine braking
Remember to make use of engine braking in addition to foot braking. When descending a grade, if only the foot brake is used, the brakes may start working improperly because of brake fluid overheating, caused by overheated brake pads. To help prevent this, shift into a lower gear to get stronger engine braking.
See also:
Hill start assist system (MT models)
Ensure that the Hill start assist system
operates properly under the following
circumstances:
1. Stop the vehicle on an uphill grade by
depressing the brake pedal and clutch
pedal, with the ...
Setting guidance volume
To set the guidance volume, perform the following procedure.
1. Select the “SETUP” menu.
2. Select the “SYSTEM SETUP” menu.
3. Select “GUIDANCE VOL” by operating the “TUNE/TRACK/CH” dial.
4. Set t ...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with the warning message
indicated by sending a signal from a sensor that is installed in each wheel when
tire pressure is severely low.
...
