Hill Holder indicator light
WARNING
If the Hill Holder indicator light does not illuminate even when the Hill Holder switch is pressed to activate the Hill Holder function, the electronic parking brake system may be malfunctioning. Immediately stop the vehicle in a safe location and contact your SUBARU dealer.
The light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds.
The light illuminates when the Hill Holder switch is pressed to activate the Hill Holder function.
See also:
Tilting moonroof
Tilting moonroof
1) Raise
2) Lower
The tilting function will only operate when the moonroof is fully closed.
Push the rear side of the “UP/DOWN” switch to raise the moonroof.
Push the front side ...
Cruise control indicator light
The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
The light illuminates when the “CRUISE” main sw ...
Monitor (if equipped)
To clean the audio/navigation monitor,
wipe it with a silicone cloth or with a soft
cloth. If the monitor is extremely dirty,
clean it with a soft cloth moistened with
neutral detergent then c ...