If the light illuminates constantly

If the light illuminates constantly while driving or does not turn off after the engine starts, an emission control system malfunction has been detected.

You should have your vehicle checked by an authorized SUBARU dealer immediately.

NOTE

This light also illuminates when the fuel filler cap is not tightened until it clicks.

If you have recently refueled your vehicle, the cause of the CHECK ENGINE warning light/malfunction indicator lamp coming on could be a loose or missing fuel filler cap. Remove the cap and retighten it until it clicks. Make sure nothing is interfering with the sealing of the cap. Tightening the cap will not make the CHECK ENGINE warning light/malfunction indicator lamp turn off immediately. It may take several driving trips. If the light does not turn off, take your vehicle to your authorized SUBARU dealer immediately.

    See also:

    Setting passkey
    1. Select the “SET PASSKEY” menu by operating the “TUNE/TRACK/CH” dial. After the currently set passkey is displayed, a new passkey can be entered. 2. Input the new passkey by operating the “TUNE/TR ...

    Rear seatbelts (except rear center seatbelt on Outback)
    1. Sit well back in the seat. 2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull ...

    Backseat
    Headroom is good in the sedan's backseat, but with the driver's seat fully back my knees pushed well into its soft backrest. With it in my driving position, for full clutch engagement, the backsea ...