Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered. Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle.
When the ignition switch is turned to the “ON” position, the indicator light will illuminate for 1 second and then flash as follows:
● When a door or rear gate (Outback) was opened: 5 times ● When the trunk (Legacy) was opened: 4 times ● When a strong impact or multiple impacts were sensed: twice (only models with shock sensors (dealer option)) ● When a light impact was sensed: once (only models with shock sensors (dealer option))
See also:
Type C audio set (if equipped)
Type C audio set (if equipped)
The audio set will operate only when the
ignition switch is in the “Acc” or “ON”
position.
- Power and audio controls: refer to page
- Radio operation: refer t ...
Cooling or dehumidifying
For cooling and dehumidification of the passenger compartment, air flows through
the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3 ...
Synthetic oil
You should use synthetic engine oil that meets the same requirements given for
conventional engine oil. When using synthetic oil, you must use oil of the same
classification, viscosity and grade s ...