Activating and deactivating the alarm system

To change the setting of your vehicle’s alarm system for activation or deactivation, do the following.

1. Disarm the alarm system. Refer to “Disarming the system” F2-18.

2. Sit in the driver’s seat and shut all doors (and the rear gate (Outback)).

3. Turn the ignition switch to the “ON” position.

4. Hold down the REAR (UNLOCK) side of the driver’s power door locking switch, open the driver’s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows:

If the system was previously activated: The trip meter screen displays “AL oF” and the horn sounds twice, indicating that the system is now deactivated.

If the system was previously deactivated: The trip meter screen displays “AL on” and the horn sounds once, indicating that the system is now activated.

NOTE

You may have the above setting change done by your SUBARU dealer.

    See also:

    GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating)
    Certification label The certification label attached to the driver’s side door shows GVWR (Gross Vehicle Weight Rating) and GAWR (Gross Axle Weight Rating). The GVW (Gross Vehicle Weight) must n ...

    Preset buttons
    How to preset channels 1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons for more than 1.5 seconds to store the ch ...

    Hill start assist warning light (MT models – if equipped)/Hill start assist OFF indicator light (STI)
    ...