Locking the doors

Press the “” button to lock all doors


Press the “and rear gate (Outback). An electronic chirp will sound once and the turn signal” button to lock all doors
and rear gate (Outback). An electronic chirp will sound once and the turn signal lights will flash once.

If any of the doors (or the rear gate/trunk lid) is not fully closed, an electronic chirp will sound five times and the turn signal lights will flash five times to alert you that the doors (or the rear gate/trunk lid) are not properly closed. When you close the door, it will automatically lock and then an electronic chirp will sound once and the turn signal lights will flash once.

    See also:

    Band selection
    Type A and B audio Type C audio Push the “SAT” button when the radio is off to turn on the radio. Push the “SAT” button when the radio is on to select SAT1, SAT2 or SAT3 reception. ...

    Initializing the registered data
    To initialize the registered data, perform the following procedure. 1. Select the “SETUP” menu. 2. Select the “SYSTEM SETUP” menu. 3. Select “INITIALIZE” by operating the “TUNE/TRACK/CH” dial. 4. ...

    Wiper intermittent time control
    When the wiper switch is in the “INT” position, turn the dial to adjust the operating interval of the wiper. The operating interval can be adjusted in five steps from the shortest interval to th ...