Hill start assist system (MT models – if equipped)
Ensure that the Hill start assist system operates properly under the following circumstances:
1. Stop the vehicle on an uphill grade by depressing the brake pedal and clutch pedal, with the engine running.
2. Make sure that the vehicle does not move backward even after the brake pedal is released.
3. Then make sure the vehicle starts climbing the grade by following the normal starting procedures.
If the Hill start assist system does not operate as described above, contact with your SUBARU dealer.
See also:
Rear view camera (if equipped)
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CVT mo ...
Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this
mode, the radio scans through the radio band until a station is found. The radio
will stop at the station for 5 se ...
Manual transmission models
Manual transmission models
The key can be turned from “Acc” to
“LOCK” only when the key is pushed in
while turning it. ...