If you park your vehicle in case of an emergency

The hazard warning flasher should be used in day or night to warn other drivers when you have to park your vehicle under emergency conditions.

The hazard warning flasher should be used in day or night to warn other drivers when you have to park your vehicle under emergency conditions.

Avoid stopping on the road. It is best to safely pull off the road if a problem occurs.

The hazard warning flasher can be activated regardless of the ignition switch position.

Turn on the hazard warning by pushing the hazard warning flasher switch. Turn it off by pushing the switch again.

NOTE
When the hazard warning flasher is on, the turn signals do not work.

    See also:

    Vehicle Dynamics Control warning light (yellow)
    The Vehicle Dynamics Control system provides its ABS control through the electrical circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics Control system becomes u ...

    Low beam light bulbs
    1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F11- 7. 2. Remove the bulb cover, by turning it counterclockwise. 3. Disconnect the electrical connector. ...

    Pulling off the fender lining
    It is necessary to pull off the fender lining when replacing some bulbs. 1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced. 2. Stop the eng ...