To disengage the service mode
Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “
” button on the remote engine start transmitter three times. The system will pause for 1 second and flash the turn signal lights once indicating that the system has exited service mode.
NOTE
When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.
See also:
Power switch and volume control
The dial is used for both power (ON/OFF)
and volume control. The radio is turned
ON and OFF by pushing the dial, and the
volume is controlled by turning the dial. ...
Checking the clutch pedal free play
1) 0.19 – 0.44 in (5 – 11 mm)
Lightly press the clutch pedal down with your finger until you feel resistance,
and check the free play.
If the free play is not within proper specification, contac ...
Maximum load limits
Never exceed the maximum load
limits explained in the following.
Exceeding the maximum load limits
could cause personal injury and/or
vehicle damage.
- Adequate size trailer brakes are ...
