To engage the service mode

Turn the ignition switch to the “ON” position, depress and hold the brake pedal, then press and release the “To disengage the service mode” button on the remote engine start transmitter three times. The system will pause for 1 second and then flash the turn signal lights and honk the horn three times indicating that the system is in service mode. When attempting to activate the remote start system while in service mode, the turn signal lights will flash and the horn will honk two times and will not start.

    See also:

    Floor mat
    Retaining pins are located on the driver’s side floor. The floor mat is secured using the built-in grommets, by placing the grommets over the pins and pushing them downward. CAUTION Make sure ...

    Measuring and adjusting air pressure to achieve proper inflation
    Check and, if necessary, adjust the pressure of each tire (including the spare) at least once a month and before any long journey. Check the tire pressures when the tires are cold. Use a pressure ...

    Parking tips
    When parking your vehicle, always perform the following procedure. - Apply the parking brake firmly. - For MT models, put the shift lever in the “1” (1st) position when on an upgrade or the “R ...