Remote start safety features

For safety and security reasons, the system will fail to start and beep the horn twice or shut down the engine during remote start operation if any of the following conditions occur.

• The brake pedal is depressed before the vehicle ignition switch is turned “on”.

• The key was already in the ignition switch.

• The engine hood is opened.

• The vehicle’s engine idle speed has reached a level over 3,000 rpm.

• The alarm is triggered by opening a door or the rear gate.

NOTE
• The security indicator light on the combination meter will stop flashing while under remote engine start operation, but the vehicle is still protected.

• If the vehicle is entered during remote engine start operation, the system will not record entry in the alarm history.

    See also:

    Cruise control indicator light
    The cruise control indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds. The light illuminates when the “CRUISE” main sw ...

    Key reminder chime
    The reminder chime sounds when the driver’s door is opened and the ignition switch is in the “LOCK” or “Acc” position. The chime stops under the following conditions. - when the ignition switc ...

    Bottle holders
    CAUTION ● Do not pick up a bottle from the bottle holder or put a bottle in the holder while you are driving, as this may distract you and lead to an accident. ● When placing a beverag ...