List names function

The voice tags registered in the phonebook are spoken by using the list names function. To use the list names function, perform the following procedure.

1. Select the “PHONE BOOK” menu.

2. Select the “LIST NAMES” menu.

3. Choose the registered data by pressing the talk switch the “TUNE/TRACK/CH” dial. Then “SELECTED” is displayed. You can choose the following menus. or by operating the “TUNE/TRACK/CH” dial. Then “SELECTED” is displayed. You can choose the following menus.

• “DIAL” to make a phone call
• “CHANGE NAME” to change the name (voice tag)
• “SET SPD DIAL”/“SET SPEED DIAL” to set the speed dial
• “DELETE ENTRY” to delete the name (voice tag) from the phonebook
• “GO BACK” to go back to the menu mode

NOTE
• After “LIST NAMES” is selected, if the OFF hook switch
pushed, the selected number is called. is pushed, the selected number is called.

• After “LIST NAMES” is selected, if no operation is performed, the memories are displayed and voice tags are spoken.

    See also:

    Defrosting or defogging the windshield
    To direct warm air to the windshield and front door windows: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Turn the temperature control dial all the way to t ...

    Checking the fluid level
    Check the fluid level on the outside of the reservoir. If the level is below “MIN” level mark, add the recommended clutch fluid to “MAX” level mark. Use only clutch fluid from a sealed container. ...

    REV indicator light (STI)
    This light illuminates when the engine speed reaches a level set by driver or when the tachometer needle enters the red zone. ...