Selecting device

1. Select the “SELECT AUDIO” menu by operating the “TUNE/TRACK/CH” dial. If no devices are registered, “EMPTY” is displayed and the mode changes to the Bluetooth® audio setting mode.

2. Select the “CONFIRM” menu by operating the “TUNE/TRACK/CH” dial. If the device is connected, “SELECTED” is displayed and the selecting procedure is finished. If the device cannot be connected, “FAILED” is displayed and the selecting procedure was not successful.

    See also:

    Rear view image display
    When the ignition switch is in the “ON” position and the transmission is in the “R” (reverse) position, the rear view camera automatically displays the rear view image behind the vehicle on the in ...

    How to insert a CD (type A, C and D)
    Hold a disc with a finger in the center hole while gripping the edge of the disc, then insert it in to the slot (with the label side up) and the player will automatically pull the disc into po ...

    Seat heater (if equipped)
    1) HIGH – Rapid heating 2) LOW – Normal heating 3) OFF – Off A) Left-hand side B) Right-hand side The seat heater operates when the ignition switch is either in the “Acc” or “ON” position. T ...