Turn off display of fuel consumption indicator
The display of the fuel consumption indicator can be turned off.
To turn off the display of the indicator, turn the ignition switch to the “LOCK” position and press the “+” button adjacent to the information display for approximately 5 seconds. Then, the information display and the clock display will blink for 3 seconds to notify that the display of the fuel consumption has been turned off.
To restore the indicator, once again press the “+” button for approximately 5 seconds.
NOTE
• The initial display setting of the fuel consumption indicator of your vehicle has been set to operational at the time of shipment from the factory.
• The average fuel consumption is calculated even while the indicator is not displayed.
• Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.
See also:
Offroad Chops
The offroad portion of Subaru's press drive consisted of a lengthy course on
California's Catalina Island, and I had a chance to tackle some fairly
demolished dirt roads. I imagine a tiny fraction ...
Selecting preset channels
Presetting a channel with a preset button allows you to select that channel in
a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset. ...
Checking the fluid level
WARNING
● Never let brake fluid contact your eyes because brake fluid can be harmful
to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly
with clean water. For ...